All Z-wave devices stopped working - Help!

[jkp]

@Dukefrukem

Where do you run a repair?

two places to run a z-wave repair:

1. use the ST app. find and open your hub, tap on the 3 dots, select Settings, open z-wave utilities to find z-wave repair
2. use the Advanced Web App go to the hubs section, tap on the name of your hub to find z-wave repair

@Dukefrukem

All 10 of my GE switches stopped working with smarthings.

what driver are you using for them? You may want to switch them to the following driver once you get them back online. Best method may be to power cycle them or reboot the hub (found in the Advanced Web App linked above).

[ST Edge] GE/Jasco Zigbee Switches and Dimmers

This is an Edge driver for GE/Jasco zigbee switches and dimmers. The intended models are the 45856 switch and the 45857 dimmer, as those are the models that I own and can test on. Power and energy monitoring are supported for both (properly scaled regardless of your hub firmware version). The switch has no other configuration options. The dimmer has the following options: Default Dim Level - The default dimming level when the device is turned on (a tap on the physical switch or an ON command from the hub). A value of 0 restores the dimmer to the previous level when the switch was last on. Values from 1-100% will scale based on the minimum and maximum dimming settings. This is the only configurable option that I’ve found that is stored in the device - all other settings are programmatic …