Is there any way to switch my 3rd Gen Smartthings hub from ethernet to wifi without doing a factory reset? If there is, I’ve seen nothing in this forum, nor is it intuitive in the app.

[image] Hub V3 Firmware Release Notes - 0.24.22 Hub Firmware Release Notes An updated firmware for the SmartThings Hub (2018) [aka V3] is being released on Thursday 12/27 between 10AM-1PM Eastern. Updated hubs will experience a couple of minutes of downtime as they apply t…

@Damian - Thanks for the help. I’ll look up a semi-soft reset. But, it almost sounds like I should try to make my setup work, at least for now. You also bring up another good point when you said, “You apparantly can do…” I think the folks at SmartThings could use a lot more formalized documentati…

I think a lot of it has to do with lots of technical people learning how to use a ton of devices from lots of manufacturers faster than smartthings staff can keep up with being able to control them. On thing they do very well is making sure that the hub can talk to damn near anything, which is a bi…

I actually created a login just to post this because I was very frustrated and then magically it worked… For some reason, it would not let me delete the hub so of course when I attempted to add a new one, it rejected it bc it was already registered. I couldn’t even get the work around to work bc …

Hi Dak, how did this work out for you? I’m trying to switch from LAN to WiFi but don’t want to lose all my z-wave devices. Did the hub reset make you lose them?

Hi - I’m sorry to say that I never did figure it out. I decided to leave well enough alone. My issue was actually needing more repeater devices to spread my Zigbee signal. Adding a couple more outlets/sockets did the trick. Good luck.

Why hasn’t this issue been addressed? The original post was from almost two years ago!!! It’s absolutely not acceptable that there is no network configuration control in the ST app. When will the app be updated to include this basic functionality? I have many frustrations with the ST platform being…

This is what you need to do. It will not delete your settings or your stored devices. Disconnect the ethernet cable if connected. Disconnect the power. Connect the hub to the power and wait a few seconds until you see the flashing blue light. Press the reset button for about 5 seconds until you…

Hi anyone! I’m struggling with switching from ethernet to Wifi. I’ve followed the above advice but the flashing orange light quickly switches to flashing blue. Is it supposed to stay flashing orange while I access the app ? Am I supposed to delete the hub and then re-add it? If so, I can’t figu…

Switch Smartthings Hub from Ethernet to WiFi

Devices & Integrations

Topic		Replies	Views
How to Update Smartthings Hub (2018) Wifi Settings? Apps & Clients	90	42299	August 30, 2023
How to change smartthings hub from ethernet to wifi? Connected Things	5	3361	September 29, 2020
Switching SmartThings hub v3 from ethernet to wifi General Discussion uncategorized	2	1139	November 25, 2019
Change wifi network on v3 hub Connected Things	22	8144	September 20, 2025
Change Wifi Settings Devices & Integrations	17	29672	April 25, 2024

Switch Smartthings Hub from Ethernet to WiFi

Related topics