Nezmo
October 19, 2018, 2:57pm
2
Yes, I reported this too in this thread …
I reset all my Crees this morning and then reset some of my stubborn Iris sensors. I got it all working for a while then slowly some of the sensors dropped again.
I was also hoping that resetting the Crees would stop the flashing that they are doing from time to time. Nope.
When I get the time I am going to contact Support as a last ditch. At the moment though it seems my Crees have been messed-up by the Cree FW update and I suspect the sensors dropping is related.
Sorry for beating a dead horse here but I’m just deflated.
Someone posted saying they were seeing a config command being sent by ST to the device at the time of the flash. I am seeing the same and I’m waiting for the next occurrence then I’m sending details off to ST Support. I recommend you do the same.
Aha, my wife is not crazy after all. Same thing here.
I think these events coincide with the time she reported Cree bulbs going nuts and waking her up. I slept through it.
[2018-10-13 3:54:06.289 AM PDT
1 day ago ] APP_COMMAND off Turn off Lamp Bedside, etc… when motions stops sent off command to Lamp Bedside true
[2018-10-13 2:19:27.413 AM PDT
1 day ago ] COMMAND configure configure command was sent to Lamp Bedside true
[2018-10-13 1:40:23.817 AM PDT
1 day ago ] DEVICE level 100 Lamp Bedside level is 100 true
[2018-10-13 1:40:22.665 AM PDT
1 day ago COMMAND configure configure command was sent to Lamp Bedside true
Another bulb downstairs at the same time. The Cree bulb Sofa1 right next to it didn’t have any unusual activity.
[2018-10-13 1:40:24.521 AM PDT
1 day ago ] DEVICE …