[OBSOLETE] Iris Motion Sensor (2nd gen, 3326-L)

[johnconstantelo]

@cvastola This discussion was broken off from another thread because it was getting huge.

You can use Mitch’s code and then switch back to ST’s default so the device runs local to the hub, or you can follow my instructions to pair the device as is and then switch to ST’s default.

Lowe's Iris Sensors (New CentraLite models)

I’ve lost track of how many Iris motion sensors I’ve bought (10+), but all have been successfully added and working perfectly. This is what I do: EDIT: I updated/added steps starting at #11. In the phone app: “Connect New Device” Pull the plastic battery tab (or insert battery) Wait until it’s “found”, and then tap the back arrow (< SmartThings) after just a few seconds. Takes you back to Marketplace. Wait (a few seconds, but your mileage may vary) for the “Not Yet Configured” entry and tap on it. Do what ever I need to name it and place it in a Room. Walk through remaining steps. Done with phone app. Right now it’s just a “Thing” In the IDE: Go to the Room where the new device was added, and select it and click on Edit. Remember, it’s a “Thing”. Change Name* to “SmartSense Moti…