I’ve added it to the driver below. You’ll need to exclude/include the device to switch from the Groovy DTH platform to an Edge driver. Once the device is using an Edge driver, you’ll be able to switch between drivers through the app without needing to exclude/include the device again.
The driver has all of the config parameters specific to that device available in the settings menu, so you’ll easily be able to set it to send reports every 5 minutes. I don’t have one of these devices to test on, so you’ll have to let me know if you run into any difficulties.
This driver isn’t set up to poll the device. If you want to go that route then I’d prefer to do it in a separate driver, and you’ll need to get the CLI installed so that you can view logs and troubleshoot. The first step though will be to get your device onto Edge using the driver below.