I’m having a problem where one of my two contact sensors is showing up with attributes (wet, smoke, etc) that it doesn’t have and whenever the door opens I’m getting a smoke notification. I needed to red-do my setup due to my screwup of deleting my location and among my devices I have a pair of Sch…

The first thing is to find out what “fingerprint” the device is reporting with. That’s the combination of the manufacturer code and the model number. (this whole concept is unique to the smartthings architecture, so you’re not going to find anything about it outside of smartthings-specific resource…

As far as changing which edge Driver it’s using, in the old architecture you could just force a change to anything you wanted. But in the new architecture, the new edge driver must have a matching fingerprint to your device or you won’t be allowed to change. And you have to have the new driver on yo…

For the one that doesn’t work it has Model: 0001-0002 Manufacturer Code: 011F-0001-0002 The one that works has Model: 0001-0002 Manufacturer Code: 014A-0001-0002 Both use the driver Z-Wave Sensor Since the Manufacturer code is different I wonder if somehow I selected different vendors; I thou…

[image] miket: Since the Manufacturer code is different I wonder if somehow I selected different vendors; I thought I used Ecolink both times. If so would there be a way to figure out what vendor the one that works was? Most likely it was just a firmware difference. We’ve seen this on a lot o…

[image] JDRoberts: Why did you select ecolink if this is a Schlage sensor? I’m confused. Schlage didn’t have an option for a contact sensor. I don’t have the box it came in, and anyway the device is a few years old so it probably didn’t have a QR code on the box (there isn’t one on the device…

[image] miket: it is sent in a field by the device Correct: the device has the identification information stored in its firmware, and will send that when queried, including at the time of joining to a new network.

How to add an old contact sensor and/or edit device type? (Schlage RS100HC)

Devices & Integrations

JDRoberts November 18, 2023, 11:05pm 6

Anyway, see if it’s on this list:

[ST EDGE] Z-Wave Sensor Driver Channel - including specific Ecolink, FortrezZ, HomeSeer, Monoprice and Zooz models

Topic		Replies	Views
Need Help Pairing Ring Contact Sensor to SmartThings Hub Devices & Integrations	38	11464	February 9, 2024
[ST Edge] Add fingerprints to released Edge drivers Support	17	2936	January 13, 2023
Edge Driver needed for the Ring Alarm Contact Sensor Using the 'Z-Wave Plus Door/Window Sensor' DTH Devices & Integrations edge_sensors	112	7010	November 18, 2024
Please.... Need help for Visonic MCT-370 SMA contact sensor and MP-841 motion sensor Connected Things	14	913	July 27, 2024
Devices recognized as generic zwave sensors Devices & Integrations	9	265	September 28, 2024

How to add an old contact sensor and/or edit device type? (Schlage RS100HC)

Related topics