GoControl GD00Z-8-GC issues with V3 Hub

[Jake_Mohl]

My haven’t had any of those kinds of issues with my gocontroler.

Try factory resetting it along with excluding it from the hub.

This helped me with getting the sensor relinked to the control unit.

Linear GD00Z-4 Z-Wave - Stays as "Unknown"

Keep in mind that you might actually need to pair the tilt sensor with the garage door opener itself under some circumstances. After fiddling with my units for days I was able to piece together this info from a few different sites and comments from people who purchased the unit on Amazon. The tilt sensor uses some kind of proprietary communication protocol and talks directly with the main unit and not through the Z-Wave network, so ST doesn’t know anything about it. This is important because the sensor talks to the unit to let it know the garage door state… If you send the controller a command to open / close the door, it waits to hear from the tilt sensor about the door state (closing / closed, opening / open). If it doesn’t get that message for whatever reason, you get one more chan…