[ST Edge/Beta] Zigbee dimmer driver (supports MOES)

Devices & Integrations Community Created Device Types
,
38

Hi, I’ve purchased two Moes 2-gang zigbee dimmers (MS-105BZ) recently. Finally manage to make them work with Smartthings.

I try to make everything step by step below.

  1. Check [ST Edge] Personal Tuya Devices - Generic EF00 Device developed by @w35l3y . Install “Personal Tuya Devices - main” driver. (Invitation link
    https://api.smartthings.com/invite/6Vjd4YPVJwjN )
  2. Connect a retractive switch to S1 and power up the dimmer according to the wiring diagram carefully.
  3. Add the Moes dimmer device to Smartthings. (Press the retractive switch connected to S1 10 times for pairing mode.)
  4. Go to the device added in Smartthings app and go to “Settings” with 3 dots in top right corner.
  5. Set the “Profile” to “Generic”.
  6. Click “OK” and return to pervious level in the app.
  7. Select the device and tap “Settings” again.
  8. Set the “Profile” to “2 dimmers” then “OK”.
  9. “OK” again to return to pervious level.
  10. Select the device and go to “Settings” again with three vertical dots.
  11. Set the followings for the Datapoints (DP).
    a. Minimum Level 1: 3
    b. Minimum Level 2: 9
    c. DP for Switch 1: 1
    d. DP for Switch Level 1: 2
    e. DP for Switch 2: 7
    f. DP for Switch Level 2: 8
  12. Try to stimulate the dimmer. (For example, cutting and reconnecting the power (be careful!!), toggling the retractive switch and so on.)
  13. The dimmer level and power status should be seen in the app in about 5 mins or shorter. Then we can control the dimmer normally.
  14. (Optional) Create child device in “Settings” menu.

Good luck my friends. :slight_smile:

2 Likes