While solving the network error problem that leaves the device inoperative because it does not allow values to be entered and you need to use the parameter configurator or association groups with Z-Wave Device Config Mc or with the child device configurator incorporated in the Z-Wave Switch drivers and Child Mc or Z-Wave Sensor and Child Thermostat Mc then you could follow this procedure.
When you open the profile you need and get the network error and data capabilities are greyed out:
- Does not remove the Child configurator device
- Perform a refresh and leave that profile selected for approximately 30 minutes even if you close the details view.
- Reopen the device and perform a refresh, the initial values should appear and start working.
- If not, wait a little longer and do the previous step again.
- You will need to perform this process on each profile that does not work.
- Once it works, it will always work until you delete the child device configuration or change the device driver if you are using Z-Wave Device Config Mc.
This problem seems to be caused by a problem in the initialization of some capabilities when the driver emits the initial values.
For some reason, those values that the driver emits, the Hub does not send them to the platform or the platform does not admit them as new events.
Even if from the smartthings page, advanced users, you send the commands with the values, these values are received in the driver and the driver emits the values, but they are not displayed in smartthings, advanced users or in the app until after about 30 minutes
@Nayelyz has already opened a report and we hope smartthings find the solution soon.