Hi,
This is a problem reported to smartthings and while it is solved, I don’t know if it will be solved and if they will break other new things, this is the provisional solution I found
While solving the network error problem that leaves the device inoperative because it does not allow values to be entered and you need to use the parameter configurator or association groups with Z-Wave Device Config Mc or with the child device configurator incorporated in the Z-Wave Switch drivers and Child Mc or Z-Wave Sensor and Child Thermostat Mc then you could follow this procedure.
When you open the profile you need and get the network error and data capabilities are greyed out:
Does not remove the Child configurator device
Perform a refresh and leave that profile selected for approximately 30 minutes even if you close the details view.
Reopen the device and perform a refresh, the initial values should appear and start working.
If not, wait a little longer and do the previous ste…
1 Like