SmartThings Motion Sensor (rev 2014), not detecting motion only temp

[justinlhudson]

I am! ST does not seem to respond on the topic, which tells me they know of issue and don’t care or can’t fix. Or will say buy our latest Motion sensor…

Brought it up again here and got nothing from anyone.

ST Motion Sensors - Stuck Active

Am I the only one that seems to have to reset motion sensors every-time a firmware patch is pushed? They keep reading temperature, but depending on state at the time. They are either stuck on or off. If stuck on, I do not notice for few days and alarm system never goes active (safety issue?). Also have to run around pulling batteries to reset. Logic should change to turn motion off at least if no motion event sent in say a minute or so. About ready to start using z-wave motion sensors instead of smart things devices…