Ring Keypad and SmartThings Hub

[Barkis (John C)]

@5ZVP

I have a ST Hub v3 and want to add the Ring Kepad Gen 2. I read that I needed to add the edge driver to have access to many of the features. Is this still true? TIA

There have been several threads lately that address the Ring Keypad. Perhaps they will answer your questions. Here’s one to get you started…

[ST Edge] Driver for Ring Keypad 2nd Gen

I have created an Edge driver for the Ring Keypad 2nd Gen. [image] You can find the source code here: https://github.com/hmorsti/SmartThingsEdgeDrivers/tree/main/drivers/SmartThings/zwave-keypad Here are some features: setting the PIN code for the “disarm” and “arm home” buttons (you can set an empty PIN too) the PIN code can handle long pressed digits - they are then mapped to the letters: 1-9 is mapped to A-I 0 is mapped to “@” wrong PIN signal motion sensor power source indication most alarms support strobe only and some support siren only panic combination (hold simultaneously “X” and “Check” buttons) doorbell with selection of 5 sounds entry and exit delay counters most configuration options were mapped in the settings Due to the limit of 20 components per device I commented…