Keypad for use with STHM with Edge driver?

[mooch91]

Hey all,

With my Iris/Centralite keypad no longer working after the Groovy shutdown (using Rboy’s driver and app), I’m looking for an alternate kepyad that I can use for the family to arm/disarm STHM.

Is there anything out there that works with an Edge driver and can be used to control STHM?

Is anyone working on a driver for the Iris/Centralize zigbee keypads?

Thanks!

[fido (Mike)]

Ask in this thread

https://community.smartthings.com/t/post-requests-for-edge-drivers-here-community-created/237327/1403

[mooch91]

Thanks. I have and will ask again.

[milandjurovic71 (Milan)]

I have seen Ring keypad gen2 edge driver somewhere.

Found it

[ST Edge] Driver for Ring Keypad 2nd Gen

I have created an Edge driver for the Ring Keypad 2nd Gen. [image] You can find the source code here: https://github.com/hmorsti/SmartThingsEdgeDrivers/tree/main/drivers/SmartThings/zwave-keypad Here are some features: setting the PIN code for the “disarm” and “arm home” buttons (you can set an empty PIN too) the PIN code can handle long pressed digits - they are then mapped to the letters: 1-9 is mapped to A-I 0 is mapped to “@” wrong PIN signal motion sensor power source indication most alarms support strobe only and some support siren only panic combination (hold simultaneously “X” and “Check” buttons) doorbell with selection of 5 sounds entry and exit delay counters most configuration options were mapped in the settings Due to the limit of 20 components per device I commented…