Reseting Bosch ISW-ZPR1-WP13 and Visonic MCT-340 E sensor?

[jkp]

Bosch Motion Sensor (ISW-ZPR1-WP13) : Smartthings v2 hub

For the record, these are Zigbee sensors. They have their own system for exclusion. I got them used on Amazon and figured they’d need a reset in order to pair. I was right. The instructions are detailed, but if you don’t have them and are having trouble pairing, do the reset sequence: remove the top two batteries press and hold the tamper switch between them Reinsert the right battery, then the left. let go of the tamper switch put backing on the sensor Do this as you have “Add a thing” active and it’ll likely pop up. If not, do the reset sequence again.