Beginner question here. With the switch towards Edge drivers I’m trying to re-setup all my Aqara contact sensors. The steps I’ve taken so far were not enough to successfully connect any Aqara contact sensor yet:
- deleted all old Aqara sensors from my Smartthings hub (in the app and in the online IDE)
- deleted all Device Handlers and Smartapps from IDE
- deleted all Ikea tradfri zigbee extenders (and physically turned them off)
- Enroll to the channels where the Edge drivers are (Yakov and Veon)
- Actually install drivers from those channels (this step I missed - while I was already trying to connect all the sensors many times)
- Changed zigbee channel to 20
- Tried pairing the contact sensors as per opening post description.
Note all my contact sensors look like this type: MCCGQ11LM (but not sure how I can see if they are maybe the unsupported version: MCCGQ14LM as per this page: [ST Edge/Beta] Xiaomi/Aqara/Tuya zigbee sensors driver )
Any mistakes I am making? Your help would be very much appreciated!