Monoprice Z-Wave Motion Detector not working

[Ross]

I just tried the Z-Wave repair, no luck. I’ll try removing the battery.
I did make some headway by following some ideas in the thread below. It’s now displaying the temp and battery. Although the temp shows 66 degrees which isn’t correct and the battery shows 100%, so maybe that’s not correct either.

[RELEASE] Monoprice/Linear/GoControl WAPIRZ-1 Motion Sensor with Temperature and Battery Device Type (Updated)

Monoprice and Linear/GoControl WAPIRZ-1 Motion Sensors with Temperature Device Handler These devices are a motion sensor which also have a temperature sensor built into it. This device handler also supports the Z-Wave Plus devices (they have slightly different specs but support has been added for them). Support has also been added for v1 and v2 hub ifingerprinting for easy identification. Ideally install the Device Handler BEFORE pairing the device for easy setup. [IMG_7136] [IMG_7137] [IMG_7135] Classic App [image] The Monoprice device can be bought directly from Monoprice for about $22 (free shipping) here: www.monoprice.com/product?p_id=10796 Monoprice has a new range of Z-Wave Plus devices for about $30 (free shipping) which can be found here: The Linear/GoControl device can…