Ikea Motion Sensor as place holder

I added another Ikea motion sensor. It paired like my others but in looking at the IDE, this one shows as a “place holder”. The hub and zigbee fields are both blank. It reports motion and battery levers but any ideas as to why it’s listed as a placeholder and not a zigbee device?

That’s because it’s using an Edge driver vs the older Groovy dth.

1 Like

FAQ: Why does the IDE list “placeholder” for my device? Can I change that?

1 Like

Thanks for the link. I knew device handlers were moving to local bit didn’t know it would be listed as a placeholder…