Hub does not support edge drivers?

[nayelyz (SmartThings Developer Support)]

@Coelhorj

Went on Github to CLI but i´m not very confident how operate it. Any guide or video with firts steps?

Here I shared some steps to start using it:

(EDGE Driver-Mc): Zigbee Drivers for Motion, Open/Close, Moisture, Smoke-Co Sensors and others Devices

Hi, if, by offline you mean that it shows the cloud icon like in this picture you shared: This means the capabilities weren’t initialized and your device is not reporting new values, this could be because: The joining process wasn’t completed (you need to wait in the “scan nearby” page a few seconds after the device is found) There was an error during the joining process. (you can verify this in the Hub logs) Initialize the Hub logging Download the latest release of the CLI and save it in a specific folder Open that folder in the terminal and run a simple command such as smartthings devices This will open a browser page where you have to log in to your account and authorize the access. Once it says “you can close this window”, run the command smartthings edge:drivers:logcat. It …

To install a driver that you published or that is part of an invitation, you can use the command below and follow the prompt:

smartthings edge:drivers:install

If you receive the same error, please send me the email account where you’re trying to install the drivers over DM.