Centralite 3400 Keypad Pairing

[keith.hill.85 (Keith)]

Hi. I recently got the Centralite 3400 keypad and I am unable to pair it with the hub. I know a lot of posts out there have referred to the old API platform for automation around it, but has there been any success with getting this zigbee keypad working recently? I can’t even pair it with the hub because it doesn’t show during the pairing process.

[h0ckeysk8er (Bruce Pinsky)]

@keith.hill.85

Hi. I recently got the Centralite 3400 keypad and I am unable to pair it with the hub. I know a lot of posts out there have referred to the old API platform for automation around it, but has there been any success with getting this zigbee keypad working recently? I can’t even pair it with the hub because it doesn’t show during the pairing process.

I don’t see support for it in the stock Edge drivers nor can I find a community developed one. I’d post a request in the thread Post Requests for Zwave Edge Drivers Here (community-created)

[mlchelp (michael watson)]

The only keypad automations I see after the shutdown of Groovy is for the Ring Gen 2 keypad. There about 50 bucks new or you could buy one on Ebay or Mercari.

[ST Edge] Driver for Ring Keypad 2nd Gen

I have created an Edge driver for the Ring Keypad 2nd Gen. [image] You can find the source code here: https://github.com/hmorsti/SmartThingsEdgeDrivers/tree/main/drivers/SmartThings/zwave-keypad Here are some features: setting the PIN code for the “disarm” and “arm home” buttons (you can set an empty PIN too) the PIN code can handle long pressed digits - they are then mapped to the letters: 1-9 is mapped to A-I 0 is mapped to “@” wrong PIN signal motion sensor power source indication most alarms support strobe only and some support siren only panic combination (hold simultaneously “X” and “Check” buttons) doorbell with selection of 5 sounds entry and exit delay counters most configuration options were mapped in the settings Due to the limit of 20 components per device I commented…