Originally posted in the thread [ST Edge] Driver for GE/Jasco/Honeywell Z-Wave Switches, Dimmers, Fans, Outlets, and Plug-Ins - #348 by glenmm
ST assigned a Leviton DZPA1-2BW on/off switch to the GE/Jasco community edge driver after auto-migration, and as a dimmer switch. I’m thinking back a few years now, I originally had a GE/Jasco plug in dimmer in this location that died, and I had just taken the shortcut of swapping the ZWave Network ID in the IDE to preserve automations, and it continues to be seen as a dimmer instead of as a switch.
Any option other than deleting/re-adding the device at this point? I’m assuming there’s no way to adjust the device fingerprint/force a relay profile