I don’t hardly know where to begin here. I set up my hub a couple of weeks ago. No problems adding any devices, no problems controlling anything. Last night I added 3 new GE in wall dimmers, a GE fan control, and 3 GE plug in dimmer modules. After installing everything I started including them t…

Have you tried doing a zwave repair?

No, I have not. I’m very new to all this. I did see that link in the IDE. I just click that and then…?

I believe it is also in the mobile app. It will work in the background. While it is doing the repair, things may not seem to be working correctly. I would wait like 15 minutes and then try to include/exclude or use your zwave devices. It is supposed to correct routing tables. This might make it more…

I’ll try the repair. I can’t imagine why the hub would need to be close to the in wall switches if they act as repeaters. All 4 of them are in the same gang box. 3 added just fine. The 4th wouldn’t add. people report that they need to have the hub close to the device to add things. If you do t…

I started the zwave repair. It says “click here to view progress” which takes me to the event viewer for the hub with a filter of “zwNwkRepair” preset. But that event list is blank. Nothing to indicate a repair started, is in progress, or finished.

For GE switches you should not need to move the hub. In fact doing so could confuse the mesh network setup. With GE switches over many months I have had three instances of devices falling off the network during times of platform instability. Most recently last week. The fix is to exclude from z-wav…

[image] travisr100: Nothing to indicate a repair started, is in progress, or finished. In a new tab in IDE, open hub page, click on List Events, then “from hub”. Refresh to view progress.

Again, I’m new to this. I tried the exclude last night and I expected some confirmation that the exclude succeeded. But I got nothing. Is it just blind? I exclude the device, push the button on the device, then assume it was excluded? I did open a new IDE page, open hub page, click on List Even…

I did see all of this from last night however… 2015-03-25 8:42:46.368 PM CDT 14 hours ago HUB ping ping ping 2015-03-25 8:40:24.954 PM CDT 14 hours ago HUB ep_cnt:2, ep:01 02 ep_cnt:2, ep:01 02 ep_cnt:2, ep:01 02 2015-03-25 8:40:23.943 PM CDT 14 hours ago HUB join …

All I see this morning however are pings. Nothing in there about the repair.

Strangeness

Devices & Integrations

sidjohn1 (sidjohn1) March 27, 2015, 3:04pm 12

you may want to run a few more repairs to be safe, and wait ~30mins between repairs and don’t worry about the logs to much yet. Also your GE devices may be associated to another hub from testing. This seams to be fairly common. Heres a link on how to run an exclude. Hope this helps.

Topic		Replies	Views
HELP! I Can Connect GE Dimmer to ST But Can't Control It Devices & Integrations	30	4514	January 4, 2018
Trouble pairing GE Smart Switch (Model 12727) Connected Things switch	43	63462	February 4, 2021
GE Z Wave Dimmer Switches Devices & Integrations	37	1522	April 10, 2022
GE Direct Wire Indoor/Outdoor smart switch (model 14285) zwave -- does not pair with hub Connected Things jasco	14	3807	March 21, 2021
GE / Jasco (45612) In-Wall Dimmer Won't Connect Connected Things	30	8349	April 4, 2020

Strangeness

Related topics