ST notifications for Schlage Connect not working? (April 2019)

[required_username]

Have 8-10 devices connected to ST. All work perfectly.
Added a Schlage Connect lock. Works perfectly . . . almost.
I get no audible notifications. I have a notification alarm selected in ST. What am I missing?
FWIW, Schlage has no app for the Connect

[prjct92eh2]

can you show a screen shot of the automation you have setup for the notification?

[required_username]

Don’t know which one you want. Here are two

[RBoy]

Are you using a custom DTH? Also do you have a repeater close to your lock?

FAQ: why would I need another beaming repeater if my zwave lock is already close to my hub?

This question comes up a lot. Suppose you have a Z wave lock, but the status doesn’t seem to update or commands don’t always seem to work. Typically someone in the community will recommend that you add another beaming repeater within 10 feet or so of the lock. So the question is why would you need that if the lock is already pretty close to the hub? The short answer is that the hub is busy, and it takes some load off of it if you have a separate beaming repeater near your lock. The long answer is in the following thread (this is a clickable link) @rboy

[required_username]

I have an update that may help. Last night I made a point of watching my Samsung S8 and Samsung Gear S3 wearable when the automation should have activated. It did. My phone showed no popup and no audible notification. My watch didn’t vibrate, but I did se a message the automation worked. Now, if I can only get an audible tone on my phone or get my watch to vibrate.

[required_username]

Notification for the ST app was “off” in my phone settings. Thanks for the help