[ST Edge] vEdge Creator: a virtual device generator for end users

[orangebucket (Graham)]

@Terri_Baker

Which driver are you using for the Ikea button?

It is the ‘Zigbee Button’ in @iquix’s channel. The invitation link to the channel is in this post.

[Edge Driver] Hue Motion Sensor (No Hue Bridge)

I made an Edge Driver for “Hue Motion Sensor” [31u0gojmGSS.AC] This is a port of the well known DTH by @bogdanalexe90 Hue motion sensor (use ST hub, but no hue bridge) - Devices & Integrations / Community Created Device Types - SmartThings Community ConfigureReporting values are adapted from the DTH. You can install the driver to your SmartThings Hub with the Invitation link that I’ve created. https://bestow-regional.api.smartthings.com/invite/qWjB0pNyY62y Click Invitation Link → Enroll your ST hub → Goto Available Drivers → Install Hue Dimmer Switch driver → Pair your device These two preferences are implemented in the Edge Driver: Temperature Offset : applied when next temperature packet is sent from the device. Motion Sensitivity : Low/Medium/High. default value is High. You’…

It only applies to the Shortcut Button. Reading the code it appears that unlike the IKEA Button DTH used for the On/Off, the Held event is being sent on button release. I was only using the button for Pressed so I don’t know if I’d find that annoying.