Sensors shows open in ST but is closed

[BBoy486]

Thanks. I just changed the batteries and I restarted the hub but didn’t do it for a full 15. I’ll try that next and report back. [quote=“JDRoberts, post:2, topic:46814, full:true”]

@BBoy486

Like the topic says I have a few sensors at the smart things hub is showing as open even though they are in the closed state. I pretty sure I’ll have to remove and re-add them but this is a constant thing with this platform is there any other way to have smart things update the status so it reflects that is close instead of open when the doors closed?

I’m sure that’s frustrating. There are several things that can contribute to this, so usually you just have to eliminate one issue at a time.
The following is the usual troubleshooting checklist:

FAQ: My Sensor (any brand) is Stuck on Closed (or Open)

When any sensor gets “stuck” in one reporting state, open or closed, it’s almost always one of the following: Low battery. once the battery gets down to about 30%, the signal strength drops by a lot. It just may not be able to report. So you may want to try just changing the battery if it’s getting low. sometimes a new device gets delivered with a bad battery, it can happen. orphaned nodes. Zigbee does have a vulnerability to this. The fix is to unplug the hub for at least 15 minutes, including removing the batteries. This will cause all the zigbee devices to realize they’ve lost connection to the network, and then when you plug the hub back in the address tables will get rebuilt. You may not see an improvement until the next day, it can take a while for the changes to propagate…

[/quote]