Sensor offline reports over the past few days

[Danabw (Dana)]

You might try something along the lines of what I did. I had installed the custom DTH from this thread a while back to turn one of my extra Visonic sensors into a leak sensor.

[RELEASE] An alternative multipurpose Visonic Door/Window Sensors DTH + sensor modification instructions

Hi, Here is an alternative multipurpose Visonic Door/Window Sensors Device Handler. There is a discussion thread about this sensor here I was originally posting this DTH in the thread, but someone suggested I should start a new thread to make it easier for comment and searching. So here we go. With some modifications, the sensor can be used as leak/water sensor smoke detector (for wired smoke alarm) tilt sensor to use for mailbox sensor or garage door sensor Since they are only $10 a pieces, I can afford to put the modified leak sensors in every room which may have water problem in my house. Comparing spending like $30 a piece for a real water sensor in the market. And if you already have a wired smoke alarm system, you can connect them to the visonic sensor and report status back…

When I pulled and reinserted the battery on one of my Visonic sensors that was offline, it came back up using the custom DTH above. Then went into the IDE and changed the DTH back to the desired SmartSense open/close) and it’s been fine since then.