[RELEASE] Official Monoprice Motion Sensor with Temperature, Tamper and Battery Device Handler

[Awestun]

@RBoy

just noticed that for all sensors it says " * networkSecurityLevel: ZWAVE_S0_FAILED"

Having An Issue With networkSecurityLevel: ZWAVE_S0_FAILED

Hi New to SmartThings and Z-Wave, not new to home integration. SO, here’s the problem: I have a SmartThings hub V3, all set up. I have three Fibaro Smoke Sensors, that used to be connected to a Z-Stick. I excluded them all from the Z-Stick, and added them to the SmartThings Hub. One of them works perfectly, the other two will not show the battery level, although will show temperature (and that there is no smoke…). When I have explored this further, the two that won’t display the battery, have the ZWAVE_S0_FAILED message in the Data section of the SmartThings webio. I have excluded all of the devices and just added a single device. The same two devices show up as ZWAVE_S0_FAILED, every time, and the third device always shows up as ZWAVE_S0_LEGACY. I am at a complete loss. I have …

so it means it didnt complete the pairing process correctly.

I excluded and re-paired (right next to the hub) but its still showing the same security error.

then to rule out your dh, I commented out the fingerprints, excluded and re-paired and let it used the ‘built-in’ dh. motion is still stuck and still have the " * networkSecurityLevel: ZWAVE_S0_FAILED "

so, obviously its something wrong with the monoprice zwave plue motion and temp device as its happening to 7 of the same devices.