[RELEASE] Fibaro FGS-222 Double Relay Device Handler (Also Philio PAN 02/04)

[TmpR]

I came here looking for a device handler for my Philio PAN06 as all the other dual relay device handlers switch endpoints 1 & 2, and the PAN06 uses 2 & 3 for S1 & S2 respectively. I’d already updated erocm1231’s generic dual relay handler and was using his sync smart app to create virtual devices, however this is a much better solution!

So I’ve taken the code you’ve already written and stripped out all the fibaro stuff, added a few UI tweaks and published a handler specifically for the Philio PAN06.

If anyone else is looking for a handler just for the Philio PAN06 / TKB TZ06 Dual Relay in-wall module then check it out…

[RELEASE] Philio PAN06 / TKB TZ06 Dual Relay Device Handler

There are a few Philio device handlers out already, but none of them seemed to work correctly with the PAN06. This is because it actually uses endpoints 2 and 3 to control S1 and S2 separately. With endpoint 1 is used to control both S1 and S2 simultaneously. To solve this problem I’ve updated cjcharles’ device handler to work solely with the Philio PAN06 / TKB TZ06. I’ve also added some UI tweaks and the turning on/turning off states. This handler makes use of erocm1231’s published child device handler, so there no need to install any other handlers or apps and you’ll get 2 child devices (3 devices total) in your list of things. After you have installed the handler and changed your device to use the new “Philio Dual Relay” device type, goto the device on your phone and click the cog i…