Problems Setting Autolock with Z-Wave Lock PH Edge Driver

[JohnRichard (John Nadeau)]

@Puzzling

As for a mesh issue, wouldn’t that be across the board and not just for a single command?

That seems to make sense (i.e. either that device is getting all or none of the commands).

Although I will share we had a Mesh Issue that would not resolve itself. Rebuilding the Z-Wave Network did not resolve it as well as the other typical steps. Then killing the power to the entire house solved it instantly… well… I suppose it solved it when I actually turned the power back on

Here’s the link to my step-by-step

@JohnRichard

Odd Behavior:
We have a house with 8 Schlage Smart Deadbolts, and various other z-wave and wi-fi devices.

All 8 Schlage Locks went offline at once and would NOT come back online. Upon power-cycling the Locks, they would come online, but wouldn’t respond consistently to commands and were very sluggish (at best).

Tried the traditional fixes… like in this order:

1. Pull Batteries from Schlage Locks
2. Power-Cycle Wi-Fi Modem/Router
3. Power-cycle SmartThings Hub (including internal v2 Hub Internal Batteries)
4. Z-Wave Network Repair

Z-wave Light Switches seemed to work OK, but were a bit sluggish.

It occurred to me that even though we were power-cycling the various key components, there was still an extensive Z-Wave Mesh Network which remained active throughout the home across 42± Light Switches which were never reset.