New ST user unable to configure device parameters Qubino flush dimmer

Hi all, I really need to know how to set the parameters on my Qubino flush dimmer. It seems really simple all I have to is change the configuration from a 0 to a 1.

Nowhere is there a guide (that I can find) on how to do this!!!

Can someone advise exactly how I change this elusive 0 to a 1?

Configuration parameters
Parameter no. 1 – Input 1 switch type
Available config. parameters (data type is 1 Byte DEC):
 default value 0
 0 - mono-stable switch type (push button) – button
quick press turns between previous set Dimmer value
and zero
 1 - bi-stable switch type
NOTE: Switch connected to S1 terminal is a master switch.
It activates the basic functionality of the Dimmer
Parameter no. 2 – Input 2 switch type
Available config. parameters (data type is 1 Byte DEC):
 default value 0
 0 - mono-stable switch type (push button) – button
quick press turns between previous set Dimmer value
and zero
 1 - bi-stable switch type
NOTE: to enable this function, Parameter 20 or Parameter
100 has to be set.

This might help:

Hello,
for these you either need the Z-Wave tweaker DH or use the DHs for the device that already contain config parameter support like @erocm1231 's handlers or mine below:

2 Likes

I need to put Qubino input in potentiometer 0-10v

parameter 1 . (input 1. value 2)
is it possible

thank you

Hi,
Is there a way to set parameters on the Qubino flush dimmers, now that we can’t create DH?