Piling on.
I have a VMB3010r base station with a number of older H11 cameras. I’ve had the integration with ST working for years, primarily triggering motion notifications in ST while using Arlo to control the cameras. Around December 23, the motion detection suddenly just stopped working in ST. Arlo, of course, recorded, the devices were still in ST - the trigger notifications just seemed to STOP.
I found this thread and thought that perhaps the shift in schemas suddenly caught up to me? So I removed the cameras from ST, deleted the integration to Arlo, did a bit of cleanup in Arlo (camera names, etc), and redid the link between Arlo and ST. I receive the same error as above.
If I go back into the settings in ST, look at Linked Services, select “Arlo”, the Host and cameras show up.
I go into Pistons, reselect the correct physical devices to link the camera motion triggers properly into the code.
…. And nothing happens.
BTW - When I perform the link, the SmartThings mode is not established in the Arlo app. I’m assuming that is supposed to happen?
Any thoughts?