Hi @Greg_Williams ,
I hate to say this, but I just purged old code I wasn’t using anymore - some of which was a doorbell DTH for the MimoLite! I never thought anyone else would do it, so I said “it’s gone”.
But!
Check out this discussion: (it’s an oldie)
and this DTH:
/**
* MimoLite Doorbell Device
*
* Copyright 2014 Todd Wackford
*
* Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except
* in compliance with the License. You may obtain a copy of the License at:
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software distributed under the License is distributed
* on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License
* for the specific language governing permissions and limitations under the License.
*
* Instructions: Once you install this device type into smartthings and have the mimolite hooked up to your
* doorbell you will need to configure the mimolite. Go to the doorbell and hold the doorbell
* button down. At the same time, you will need to tap the "configure" button on this device's
* detail screen. After 5 seconds, you can release the doorbell button.
*
* Now press and release your doorbell button as you normally would. You should see the device
show original