Issue with zwave switch and child mc

[Mariano_Colmenarejo]

@jpstewart

unsolicited report configuration.

Try to set parameter 3, to value =1 and size=1

Create a configuration device in preferences.

This is the thread for device config

(EDGE Driver-Mc): Z-Wave Device Config Mc

(New Release) New Edge Driver Z-Wave Device Config Mc This is the initial version of the driver that allows reading and writing configuration parameters in Z-Wave devices. There is a New Version Aug/18 There is the Association Groups Version Sep/22 Link to new version with Wake_Up command class. Apr-23 Important note: If your device uses the Z-Wave Switch and Child Mc or Z-Wave Sensor and Child Thermostat Mc driver then they already have this driver built in to configure any parameter or association group creating a virtual configurator device and you don’t need to change to this driver: Link to post release Z-Wave Switch and Child Mc and Z-Wave Sensor and Child Thermostat Mc device config built in My Recommendation: The parameters that can be changed with the preferenc…