Ikea Motion Sensor not pairing to the hub

[Paul_Oliver (PCO)]

Sorry I don’t have that device. But see the following

State by installing the ZigBee Contact Mc driver: see below

(EDGE Driver-Mc): Zigbee Drivers for Motion, Open/Close, Moisture, Smoke-Co Sensors and others Devices

Updated list of Edge Drivers published in my channel (New RELEASE) New Edge Drive Zigbee Light Multifunction Mc: This Driver has all the functions of the Zigbee Level ColorTemp Bulb Mc driver, which it replaces and will not be updated any more. Added Color Control Capability with profiles for RGB and RGBW with 2700k-6500k Color temperature. Thanks to the suggestion and collaboration to do the tests for @milandjurovic71 Works with lights, led strips with profiles : Switch & Level Switch, Level & ColorTemperature Switch, Level, RGB, RGBW, RGBCCT, CCT Could work with zigbee single dimmers, but not tested Link to the Zigbee Light Multifunction Mc Driver Thread Included Devices : See this link https://community.smartthings.com/t/new-release-beta-edge-driver-zigbee-light-multifunc…

Then try to pair the device per the Ikea instructions next to you hub. See the following if it is not working properly after pairing.

Ikea Parasoll Window/Door Sensor - Hack to pair them if stuck at closed state

Hey everyone! Just bought a bunch of Ikea Parasoll sensors and wanted to share a trick in case somebody else at some point faces the same issue I encountered. Upon pairing the sensor for the first time (using the Mariano’s Zigbee Contact MC driver,) the signal strength and battery status appeared after about a minute but the sensor would get stuck as closed, no matter how many times I triggered the open/close with the magnet. The light flashes on the sensor, but no state change in ST. The simple hack is to delete the device from ST and re-pair it by pressing the sync button 4 times within 5 seconds. ta-da!! They respond quickly and are quite thin too which makes them perfect from small window frames. Great buy and good quality sensors for the price tag