3x0088
(Eric)
November 12, 2016, 11:00pm
1
I have CoRE installed on phone, and have two pistons running with no problem, However when I sign into IDE it only shows the CoRE installed and no smart Apps running. Both pistons running show on my phone under smartapps. Is there away or have I left something out as to why they don’t show under IDE. Thanks in advance
3x0088:
I have CoRE installed on phone, and have two pistons running with no problem, However when I sign into IDE it only shows the CoRE installed and no smart Apps running. Both pistons running show on my phone under smartapps. Is there away or have I left something out as to why they don’t show under IDE. Thanks in advance
I’d ask your question in the core author’s thread. Someone there should know.
UPDATE DEC 19 2017:
If you are still using CoRE, please update to the latest version as soon as you can. Here’s what changed:
v0.3.16e.20171219 - RC - Replaced recovery safety nets using unschedule() with a much more optimized method that does not affect ST as much as unschedule() does
This is important as CoRE has been identified as a major choke point on a certain method that it uses (ST describes that as expensive in their documentation. As it turns out, it is. With ST’s help, CoRE is now able to recover from timeouts much faster and with a lot less resources than by using its own recovery safety net. You should also consider moving on to webCoRE instead, as CoRE is no longer actively maintained and only gets critical updates.
Thank you
Continuing in the BETA process of CoRE (mil…
CSC
November 13, 2016, 1:56am
3
Piston don’t show up as app in the ide.
CSC
November 13, 2016, 2:29am
5
Thanks, not aware about that
1 Like
3x0088:
I have CoRE installed on phone, and have two pistons running with no problem, However when I sign into IDE it only shows the CoRE installed and no smart Apps running. Both pistons running show on my phone under smartapps. Is there away or have I left something out as to why they don’t show under IDE. Thanks in advance
Hi @3x0088 ,
Where in the IDE did you look? You should find them within My Locations and then Installed SmartApps.
1 Like
bobbles
(Bob)
November 13, 2016, 9:24am
7
You probably know this but make sure you login to the correct shard.
Bizarrely you can log into all 3.
Only the shard your hub is connected to will show the apps.
3x0088
(Eric)
November 13, 2016, 9:06pm
8
Thanks that’s where they were, I didn’t realize you could sign in else where
1 Like