So I just wired up 3 of these in a 3 gang box. The non smart switches were wired with main (Line) power to one, and then jumpers to the others. So I did that, and they power up just fine. All good. I did the same with the white (neutral). Jumped one to the next, and then the final one I wired in…

Can you take a photo of the switch showing the model number that @JDRoberts alluded to earlier and post it?

As others have mentioned, the ST app is horrible at adds. I have had some new devices that have taken many many tries and believe me, I have a very strong mesh. I truly believe it’s the app at fault as when I’ve used a Minimote to do an add when struggling it always works. Just keep at it. And b…

[image] JDRoberts: The model number will be stamped onto the front of the switch. @JDRoberts newer/latest switches/dimmers/outlets have date code and model on top of the switch along with QR code. [image] EMTPJ: I am thinking it has to do with the neutrals being jumped from one to the ot…

Try adding them using the Z-wave “brand” from the list. If there is a QR code on the face of the switch, make sure you leave the switch plate cover off because you’ll need to scan it as part of adding. If you get the error again, try backing out to the devices tab and scrolling through your rooms or…

What is a minimote? I am frustrated to be sure, but I dont want to give up!

A minimote is a now discontinued handheld remote from Aeotec that was useful back in 2015 and 2016 for adding zwave Classic (4th generation) devices to the network when they couldn’t be brought close to the hub since those devices didn’t have Explorer Frames. Old technology for an old problem. Thes…

Pulled the plate cover. Model is indeed ZW3005. No QR codes.

I am in strong belief that the devices are being added…This is confirmed because when you go to exclude, then they get excluded. I would go through the process but this time click up, click down, click up, click down. Wait in the App until it times out. Close the App or even log out, then open the A…

[image] EMTPJ: Pulled the plate cover. Model is indeed ZW3005. No QR codes. You must have gotten some new, old stock sitting on the shelf for a while. All the GE/Jasco models in the past 3 years or so will have a QR code. What phone are you using? As @rontalley said, if they are being exclud…

[image] EMTPJ: Pulled the plate cover. Model is indeed ZW3005. No QR codes. You could try calling Jasco support and find out why they don’t have a QR code. Just tell them that your hub is asking for it. Jasco’s zwave site is here: Contact Us edited: sorry, I forgot that you had been give…

GE Z Wave Dimmer Switches

Devices & Integrations

EMTPJ (Patrick) April 6, 2022, 7:32pm 37

Been thinking of just such an item! Get them all paired up initially, close to the Hub, etc. Test them to make sure they sync up, etc. Then actually install them where intended…

Topic		Replies	Views
Trouble pairing GE Smart Switch (Model 12727) Connected Things switch	43	63392	February 4, 2021
GE / Jasco (45612) In-Wall Dimmer Won't Connect Connected Things	30	8327	April 4, 2020
GE Direct Wire Indoor/Outdoor smart switch (model 14285) zwave -- does not pair with hub Connected Things jasco	14	3781	March 21, 2021
Z-Wave Dimmer switch not found by SMartThings problem Connected Things leviton	24	12037	November 27, 2022
GE In Wall Smart Switch Not working Connected Things	26	28961	August 14, 2021

GE Z Wave Dimmer Switches

Related topics