Bummer.
Here is try one:
/**
* Enhanced GE/Jasco Dimmer Switch
* Author: Ben W. (@desertBlade)
*
* Based off of the Dimmer Switch under Templates in the IDE
* Copyright (C) Ben W.
*
* Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except
* in compliance with the License. You may obtain a copy of the License at:
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software distributed under the License is distributed
* on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License
* for the specific language governing permissions and limitations under the License.
*
*/
metadata {
definition (name: "Enhanced Dimmer Switch", namespace: "desertblade", author: "Ben W.") {
show original
Using a different zwave command.
Here is try 3:
/**
* Enhanced GE/Jasco Dimmer Switch
* Author: Ben W. (@desertBlade)
*
* Based off of the Dimmer Switch under Templates in the IDE
* Copyright (C) Ben W.
*
* Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except
* in compliance with the License. You may obtain a copy of the License at:
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software distributed under the License is distributed
* on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License
* for the specific language governing permissions and limitations under the License.
*
*/
metadata {
definition (name: "Enhanced Dimmer Switch", namespace: "desertblade", author: "Ben W.") {
show original
Basically same as above but adds the additional field for how long (2 seconds). If it works I will clean it up some. This one is a little buggy with repeated commands since it waits the 2 seconds (plus 2 more seconds) to process anything.
Let me know if either works.
1 Like