GE/Jasco 45857 Zigbee dimmer ramp rate and limits

[pizzinini]

Just a note on the enhanced DTH… you would only use temporarily it to set the dim rate parameters. once they are set, they are stored in the switch itself. Once it is configured as you like it you can switch back to the original DTH and the parameters will stay.

Another note: I recommend you write down your original settings before you start changing them Jut in case…

Here is what I used:

GE 12729 Dimmer fade when issued a set level command

Bummer. Here is try one: Using a different zwave command. Here is try 3: Basically same as above but adds the additional field for how long (2 seconds). If it works I will clean it up some. This one is a little buggy with repeated commands since it waits the 2 seconds (plus 2 more seconds) to process anything. Let me know if either works.