(EDGE Driver-Mc): Z-Wave Edge Drivers and others with FIBARO devices:

[Mariano_Colmenarejo]

@rowschank

The extra settings (reporting periods, switch modes, etc.) are obviously gone, but I rarely used them so it’s fine. But it’s unfortunate, because the hardware is really good.

Hi @rowschank

You can use Z-Wave Device Config Mc to configure the parameters according to device manual.

Preform a driver change to Z-Wave Device Config Mc then do the configuration ad return to the original driver.

Now there is a problem when you change to this driver, all routines for this device are deleted. I hope will fix soon.

(EDGE Driver-Mc): Z-Wave Device Config Mc

(New Release) New Edge Driver Z-Wave Device Config Mc This is the initial version of the driver that allows reading and writing configuration parameters in Z-Wave devices. There is a New Version Aug/18 There is the Association Groups Version Sep/22 Link to new version with Wake_Up command class. Apr-23 Important note: If your device uses the Z-Wave Switch and Child Mc or Z-Wave Sensor and Child Thermostat Mc driver then they already have this driver built in to configure any parameter or association group creating a virtual configurator device and you don’t need to change to this driver: Link to post release Z-Wave Switch and Child Mc and Z-Wave Sensor and Child Thermostat Mc device config built in My Recommendation: The parameters that can be changed with the preferenc…