Edge Driver for Qubino Thermostat?

[jaidank (Aidan Killian)]

There is an older thread (Groovy-related) about a slight variant of your thermostat:

Has anyone actually got the Qubino Thermostat (ZMNHID3) working successfully?

I’ve got it wired to 120 and am using the handler that thesmartesthouse points to. First thing I see is that there is nothing in that handler to use anything with the sensors on it, ie putting a door sensor on one of the contacts, even after you “enable” it. To be perfectly honest, it seems like a hot mess. Anyone have any recommendations? I’d like to use the flush 1d relay handler, but it doesn’t quite seem to work.

The implication is that support has been dropped in favour of the newer V2 version.

The zwave.eu site has information also:

https://manual.zwave.eu/backend/make.php?lang=en&sku=GOAEZMNHID1

The Qubino site has a link to detailed manual which includes the information needed if you were going to write an Edge driver yourself:

Flush_On%20Off_Thermostat.pdf

Finally, the openhap site has information that suggests the Manufacturer Id is 51 and the Type: 5 but no Model number.

It seems much more complicated than my Secure Thermostats.