davidwlam
(David Lam)
September 21, 2017, 4:39pm
1
Which device handler do i use for local processing? I tried smart sense and it worked but it doesnt show temp and battery.
Thanks
It will depend on the exact model that you have. See the following thread:
Hello, first time posting and I’m mostly a newb to smartthings, but have gotten a few door sensors setup as well as my Honeywell thermostat so I’m starting to get a feel for things but still have a lot to learn.
Question for the board: Has anyone had success setting up a Bosch Motion Detector in SmartThings? Specifically I have model ISW-ZDL1-WP11G, which is supposedly wireless as well as ZIGBEE compatible. I got the detector from a previous install so I have no documentation on it (other than a zigbee id), and have not had success searching online. I’ve been unable to pair it trying both manual entry on the smartthings portal as well as searching via my android app. Any thoughts would be appreciated, thanks!
davidwlam
(David Lam)
September 21, 2017, 9:52pm
3
I have the MCT-340 E which a lot of people purchased, I did not find anything in that thread that was helpful.
I’m not aware of a Bosch MCT 340 E. There’s a Visonic Open//close sensor with that model number, is that what you have?
If so, see the following:
https://www.mydigitaldiscount.com/connecting-your-visonic-mct-340-e-window-door-sensor-to-smartthings.html
davidwlam
(David Lam)
September 21, 2017, 10:12pm
5
I got it paired and working but I need it to run locally now, that is the problem. I got it running locally when i set it to smartsense motion detector but there is no temperature reading and also the motion is more grayed out than usual.