@RottenMutt I’ve sent you a PM/DM to help gather some logs.
I recently downloaded and installed the latest official HomeSeer edge driver. I also did a round of testing with my HSM200 multi-sensor, and I am happy to report that the driver capabilities are working as expected for my use cases.
Setting LED color, LUX/Illumination reporting, Motion Sensor, Motion clear, and Temperature reporting, all are working.
The latest homeseer driver is located here:
I can not get mine to switch to this driver. It’s listed as EZ MultiPli on my app and uses the ZWave sensor from smartthings. I downloaded the driver from Homeseer to my hub but it won’t let me switch it. I figure my fingerprint is wrong so it won’t work. The ZWave sensor driver works except the color control. I can’t change the color it only comes on as white.
Any ideas how I can switch it to the Homeseer driver.
@Gavin things continue to move pretty quickly. Based upon the work in the HomeSeer channel, my recommendation is to use their drivers for all of the supported models. Neither the beta drivers mentioned in this thread, nor the HomeSeer Official drivers were tackling the EZ MultiPli fingerprints by default.
However, I can share that the SmartThingsCommunity/SmartThingsEdgeDrivers does have a matching profile for the EZ MultPli
I would recommend setting up the channel referenced in this post see if it meets your needs:
HomeSeer driver channel
For WS-100 driver. Can you add mfg 0184 for hs/hd100 switch. I have three generations of the ws-100 switches.
I have gone radio silent on this thread since the corporate drivers were released. With that being said, I did make a quick set of changes to add these fingerprints and push to prod. Hopefully it helps with the DragonTech manufactured devices.
Thank you. Your drivers are the only ones for the 100 series drivers.
Happy to help where I can.
I have a gen1 HS-FLS100+ that has lost all functionality within smartthings over the last couple of weeks. The device is now listed as a z-wave switch and only has on/off capability. No motion, lux displayed anymore. Is there a beta driver available that can be shared?
I believe this is addressed in the manufacturer provided beta drivers located here:
Unfortunately that driver only supports the Gen2 model. I reached out to Homeseer and they confirmed the Gen1 model is no longer supported and referred me to the community for a beta driver.
I have a driver for the FLS100+ (gen 1), PM me for details. At some point I’ll post the full details but for now I’m dealing directly with folks.
I can confirm this driver is top notch! I had Zwave mesh issues that muddied my initial results but it’s been solid for the last 4 months or so. I have 3 with a mix of S2 and S2 failed and they work beautifully.
A huge thanks to @csstup for all his work in Jan and Feb on this.
Is it possible to add the finger print for the following leak sensor? I think it’s the same as a fs100
Hey, do you still have the link for the HS fls100+ driver. I would definitely be interested.
PM me for details.
@jshessen Is this possible? Or do you think these devices are too different?
@jamesonrw – The code base was primarily focused on the “Switch/Dimmer”. I had only just began to explore the “Fan Controller” and the HSM200, but did not move forward after the release of the official driver set.
Unfortunately, you would need to work with their official channel to see if they have any interest in incorporating the fingerprint (they support both the FS100-L and FS100-W) or put in a request in this forum to request a driver. I don’t see these in @csstup driver set as of yet.
Would I be able to get the HS FLS100+ Driver?
I am also looking for the HS-FS100 Flex sensor driver.
As a new member I could not PM you.