Aeotec Recessed Door Sensor Gen5 stopped working

My door sensor (Aeotec Recessed Door Sensor Gen5) stopped working few days ago. Hit the forums and found out it had been migrated to an Edge driver by the way it is presented in the old IDE and in the app with the “Driver” option under the three dots. It shows online, but will not update the status of the device when an open or close event happens. If I change it to the _-wave switch driver an back to the Z-wave sensor driver it will update to the current state (open or closed) that one time, and no more. I have removed the device from ST entirely and re-added it. Same result. Does any one have any ideas or suggestions on how to get this device working?

Tagging @alissa.dornbos