Aeon Labs Energy Meter clamps

[sgnihttrams (ocd+adhd+alz+md+asd+fms+tldr+lol=me :))]

@Mike_Maxwell

to use and configure the probes independently one must have a custom device type, as the HEM needs to be configured to report each of it’s clamps independently. That’s probably why it didn’t work for you.
There are threads and device types out there for this already.

Yep. I found this one…

Aeon Home Energy Meter v1 -- Read Clamps Separately

01/14/2017 – Status Update #5 This Device Handler no longer works correctly. Multiple members have experienced the same issue with incorrect data being generated into the GUI. However, you may want to look at Omyn’s post where they posted an update to the code with new options and features. Might be worth a look! 01/12/2017 – Status Update #4 Informational Update: For those interested in using this code to monitor 120v line sources instead of 240v, please see post #21. If no changes are made to the code, then the HEM will assume a voltage of 240v for each line. 10/24/2015 – Status Update #3 Layout finalized, code published to github. Currently setup for 240v with ‘HVAC’ on L1 and ‘Dryer’ on L2. Example layout: [image] 10/12/2015 – Status Update #2 With everyone’s help, the baseline…

It’s the one I mentioned above.
However, I was never able to get it to work…most likely due to my previously mentioned ‘stupids’.

I will try it again with this newfound wisdom, and see if I can make it work.

If there’s anything different I need to do to monitor on-off of two different items with the two clamps using this device handler, please say something.