Add Support for GE ZW4101 (aka Jasco) Appliance Module

[h0ckeysk8er (Bruce Pinsky)]

@harobinson

Thanks for that. Getting closer. So I see the subscribed driver with the edge:drivers:installed command. But they are not available when I install a new device or try to switch the driver (has an edge driver) for an existing device. What am I missing?

Thanks

Sounds like the fingerprint isn’t matching. I see it in the fingerprint.yml for the driver:

id: “0063/5250/3030”
deviceLabel: GE Plug In Switch 12719

So wondering if your device isn’t reporting it correctly. Use the CLI or the API Browser+ from @TAustin to verify the device fingerprint that is registered with the hub.

I’ve had devices end up being set to all zeros that I needed to factory reset to get them working.