Z-wave Network repair is routing device paths thru battery devices

[jlv]

I ran a repair on Sunday and on Monday my routes were all messed up. I ran one again yesterday and now they are fine.

Z-Wave Network Repair / Routes

Checking this morning, I see some of the routes did change overnight. However, I still have hardwired devices (GE switches) that are going through multiple hops, ping-ponging back and forth across the house. The sump pump water sensor I posted above (battery powered, not woken up during any of the repairs) now looks like this. It is physically 4’ from the hub and from the SES. However, the Iris outlet is on next floor. [image] But weirder is this cropped up. 2 of my minimotes and one of my Aeon Multisensor 6s (all battery powered), now report this routing: [image] I’m not sure what to make of that – device 03 is listed twice!! It would also seem to imply I have Z-wave devices in the mesh that SmartThings does not know about. I only have 18 Z-wave devices total and they are all …