Z-wave door contact and tilt sensor does report batttery

[desertblade (Ben W)]

Here is another recent thread that talked about it.

No battery status for a few devices

I’m relatively new to ST device troubleshooting as most things I have all worked properly the first time. However, I have the following devices that show nothing for the battery levels: Aeotec Recessed Door/Window Sensor Gen 5 (I have 3 of these–one works perfect, one shows 0% battery and the other shows no battery info) FirstAlert CO/Smoke/Fire Alarm (I have 2 of these–one works perfect and the other doesn’t show the battery level) FirstAlert Fire/Smoke Alarm (I have 1 of these that does not show the battery level) All of the above are Z-wave. For each, I’ve tried the following troubleshooting steps: Remove the device and Re-add it to the Z-wave network. On the Hub, clicked “Repair Z-wave network” Waited a week or so since install to see if it will eventually work itself out. On …