Trying to turn my analog dryer smart

[GSzabados (Gabor Szabados)]

The same question was asked here.

Vibration trigger

Very new to smartthings, I actually purchased for vibration sensors. I got 2 multipurpose sensors, one for the washing machine and one for the dryer. Both have plenty of movement on the back, they pick up vibration perfectly, however the issue is if I touch them it will sense motion then it will send the alert after it clears. Also, the washing machine stops for a few seconds every so often while running, I had it running for about 10 minutes and I got 11 alerts. So I need a delay to say when there has been motion for more then let’s say 10 minutes and then there is no motion to trigger the alert. Is there anyway to do this? Thanks.

Do you have your washing machine connected to your dryer? Side-by-side or on the top of each other? Then motion will not be the right choice for you.