Just a topic to collect feature requests for this new solution module. Most obvious, which I believe is probably already on the way: Ability to monitor locks for locked/unlocked/other status.

I had the same problem with mine, everything worked find for about 25 day, then totally dead. I pulled the batteries and checked, they were both dead. I will do the same as you did and replace them, but at the price of the CR123A and needing two new batteries every 3 weeks, is not right. I notic…

I am new to Smartthings and so far very impressed at the skill and knowledge across the community. I am in the middle of implementing a security system using ST with motion sensors and door switches. It seems to me some basic functionality might be in order for the Smartapp: Smart Home Monitor - Sec…

Holy delay Batman!!! How is there not a delay zone or even delay the entire system. How does everyone disarm there system? I pull in to the the garbage and as soon as I open the door, I get intrusion alerts. If i walk in through an outside door, intrusion alerts. The list goes on. Please…

[image] Jason_Bush: Holy delay Batman!!! How is there not a delay zone or even delay the entire system. How does everyone disarm there system? I pull in to the the garbage and as soon as I open the door, I get intrusion alerts. If i walk in through an outside door, intrusion alerts. T…

Biggest thing I’d like is to be able to set a delay before triggering the full alarm so that I can turn off the alarm before it goes off causing a false. Ideally SHM would add another page after editing each alarm type (security, smoke, water, custom) where the can enter an optional delay (in secon…

The problem with the current SHM is that every open/closed switch and every motion detector is considered an intrusion device therefore, SHM will always initiate an Intrusion alert. There is no customization - one has no choice of which of these devices to use for intrusions and which devices not to…

Pretty sure you can select which devices you want to use. Uncheck “Use every open/close and motion sensor” and then select which ones you want. [image]

If anyone wants a delay, please send an email to support@smartthings.com or https://support.smartthings.com/hc/ If you’ve already sent an email, email them again to follow up on the status of the delay. The squeaky wheel gets the grease. :wink:

Thanks @Scott_Barton . I think it used to work that way, but I just double checked before I replied to you and currently I can slide the switches to the left to turn them off but no devices are listed on either page. When you save the app and return to it the switches are automaatically turned on aga…

Smart Home Monitor - Feature Requests

SmartApps & Automations

El.Zurdo (El Zurdo) September 20, 2016, 8:04pm 185

Done. It’s a kludge, but it works. Delay for Intrusion Alert in SHM - Success!.

Topic		Replies	Views
Smart Home Monitor SmartApps & Automations	68	14777	December 5, 2018
Smart Home Monitor LIVE! Apps & Clients	192	18701	October 8, 2015
Weekly Update from Alex - 05/27/16 Announcements	53	8259	June 4, 2016
Smart home monitor exit/enter delay Automation Ideas	81	21627	March 18, 2023
Smart Home Monitor vs. Smart Alarm SmartApps & Automations smarthomemonitor	47	15226	February 4, 2017

Smart Home Monitor - Feature Requests

Related topics