Same Device, Same Device Type, Different Result

[Fuzzyligic (Stuart Buchanan)]

This is definitely a problem with the configuration, one is configured with multiendpoint encapsulation and the other has not.

Let me look at the device type you were using a little later today and I will see how the configuration is set.

FYI the ListCurrentParams command can be run from the IDE.

In the thread below I tell how you can run the ResetParams2STDefaults command but in the screengrab you can see the other command. But as I said leave it with me today and when I get a minute I will write sone instructions to enable you to resolve the issue.

Noob help please -- Popp dimmer (UK model 123603)

Hi, we all have to start somewhere, yes you will need a custom device type to set the options, I have taken a look at the manual here and can see the options. I am not a coder either but I have knocked you up a custom device type that should work to install this just goto your Smartthings device handlers page here if you are in the US or here if you are in the UK and then click on [image] then choose the from code tab and paste in the code from my github page above and then click on Create you will see near the bottom of the code the resetParams2StDefaults() section, this contains all the parameters from the manual that are currently set to the default options for example below for parameter number 1, the default value is 3, just change any of the parameters values between the for…