I have a Schlage Z-Wave Connect lock installed on my front door. I have it set up via the Rboy’s app. I was hoping I could just remove the lock and reinstall it on the new door, but according to Schlage’s instructions, I need to completely reset the lock and then reinstall the Z-wave configuration once the lock is physically installed on the new door.
This is not a problem, but I don’t know how to exclude the Z-wave device. I want to make sure I can get the lock reconfigured easily before I remove it from the door.
Specifically I’m wondering about step 6. Are there other steps I must perform? What are they?
Comments? Advice? Thank you!!